The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the diesel throttle body assembly removal/installation are shown below.
12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
for Air Cooled Type Intercooler:
Remove the 2 nuts from the No. 1 engine cover bracket and No. 2 engine cover bracket.
Detach the 2 clips and No. 1 engine cover sub-assembly from the No. 2 water by-pass pipe.
Make sure to lift the No. 1 engine cover sub-assembly upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.
for Water cooled Type Intercooler:
Detach the 4 clips and No. 1 engine cover sub-assembly.
51406A
2.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY
52618
3.REMOVE LOWER FRONT BUMPER ABSORBER
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
25761B
5.DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE (for Air Cooled Type Intercooler)
17303T
6.REMOVE AIR PIPE SUB-ASSEMBLY (for Air Cooled Type Intercooler)
17030
7.REMOVE AIR HOSE ASSEMBLY (for Water Cooled Type Intercooler)
| *a | Retainer |
Release the 2 retainers and disconnect the No. 2 air tube assembly from the intake air connector and intercooler assembly as shown in the illustration.
26100G
8.REMOVE DIESEL THROTTLE BODY ASSEMBLY
for Air Cooled Type Intercooler:
Disconnect the intake air temperature sensor connector.
Remove the bolt and disconnect the fuel hose bracket from the diesel throttle body assembly.
for Cold Area Specification Vehicles:
Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose from the diesel throttle body assembly.
Disconnect the connector and clamp.
Remove the 4 bolts, intake air connector, diesel throttle body assembly and 2 gaskets.
Disconnect the connector to remove the emission control valve wire from the diesel throttle body assembly.
for Water cooled Type Intercooler:
Disconnect the connector from the intake air temperature sensor.
Remove the bolt and disconnect the fuel hose bracket from the diesel throttle body assembly.
| *1 | No. 11 Water by-pass Hose |
| *2 | No. 14 Water by-pass Hose |
Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose from the diesel throttle body assembly.
Remove the 4 bolts, intake air connector, diesel throttle body assembly and 2 gaskets.
Disconnect the emission control valve wire connector from the diesel throttle body assembly.