Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387393 CAMSHAFT POSITION SENSOR A

1GD-FTV ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CAMSHAFT POSITION SENSOR

a.

for Air Cooled Type Intercooler:

i.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

When reusing the camshaft position sensor, check the O-rings.



ii.
A346003

Install the camshaft position sensor with the bolt to the cylinder head cover sub-assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Replace with a new part if it is dropped or if it receives a strong impact.

·

Make sure that the O-ring is not cracked or jammed when installing it on the cylinder head cover sub-assembly.




iii.

Connect the camshaft position sensor connector.



b.

for Water Cooled Type Intercooler:

i.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

When reusing the camshaft position sensor, check the O-rings.



ii.
A457372C02
1.854,1.708 1.969,1.594 false
V100135

Bolt
V100136

Camshaft Position Sensor Connector


Install the camshaft position sensor with the bolt to the cylinder head cover sub-assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Replace with a new part if it is dropped or if it receives a strong impact.

·

Make sure that the O-ring is not cracked or jammed when installing it on the cylinder head cover sub-assembly.




iii.

Connect the camshaft position sensor connector.



Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY