Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH › 2020.05–2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387399 POWER STEERING OIL PRESSURE SWITCH A

1GD-FTV ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438B 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

for Air Cooled Type Intercooler:

i.

Apply a light coat of engine oil to the O-ring of the power steering fluid pressure switch.


ii.
A443566

Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
20.6 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch.




iii.

Connect the power steering oil pressure switch connector.



b.

for Water cooled Type Intercooler:

i.

Apply a light coat of engine oil to the O-ring of the power steering fluid pressure switch.


ii.
A454056C02
2.833,1.417 2.333,1.417 2.333,1.417 1.885,1.156 true 2.917,1.333 3.229,1.531 0.313,0.198 10 true *1
*1 Power Steering Oil Pressure Switch


Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
20.6 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch.




iii.

Connect the power steering oil pressure switch connector.



Hide 2.ADD POWER STEERING FLUID

Hide 4.CHECK FOR POWER STEERING FLUID LEAK

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY