Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.05
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384162 DIFFERENTIAL PRESSURE SENSOR A

1GD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.
A346701C03
1.74,1.115 2.073,1.281 2.073,1.281 2.24,1.281 true 1.531,1.042 1.052,0.906 1.052,0.906 0.885,0.906 true 2.26,1.167 2.479,1.354 0.219,0.188 10 true *a 0.677,0.792 0.896,0.979 0.219,0.188 10 true *a
*a Paint Mark


Install the 2 air hoses to the differential pressure sensor, and slide the 2 clamps to secure the 2 hoses.

HINT:

Make sure that the paint marks of the air hoses face the differential pressure sensor side.



b.

Connect the 2 air hoses to the No. 1 vacuum pipe and No. 2 vacuum pipe, and slide the 2 clamps to secure the 2 hoses.


c.

Install the differential pressure sensor to the pipe clamp with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the connector to the differential pressure sensor.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)