Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › from 2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387398 AIR FUEL RATIO SENSOR A

1GD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Replacement of air fuel ratio sensor Clear A/F sensor learning value data - (Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 51406A 1.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 2.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A443563N01
0.958,0.458 1.052,0.458 1.052,0.458 1.292,1.042 true 0.604,0.385 0.906,0.552 0.302,0.167 10 true SST

Disconnect the connector and clamp.


b.

Using SST, remove the air fuel ratio sensor.

SST
09224-00012