Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV(w/o Variable Flow Control Solenoid Valve)) › from 2021.07
RM35X0E _55 Steering _078944 POWER ASSIST SYSTEMS _0389112 VANE PUMP(for 1GD-FTV(w/o Variable Flow Control Solenoid Valve)) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV(w/o Variable Flow Control Solenoid Valve))  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket to the pressure feed tube assembly.


b.
C412799C01
0.406,1.406 0.375,1.042 true 0.292,1.438 0.51,1.635 0.219,0.198 10 true *a
*a Stopper


Install the union bolt and connect the pressure feed tube assembly to the vane pump assembly.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing.



c.

Connect the connector.


Hide 44348D 3.CONNECT NO. 2 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 2 oil reservoir to pump hose to the vane pump assembly and slide the hose clip.


Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)

Hide 6.ADD POWER STEERING FLUID

Hide 8.CHECK FOR POWER STEERING FLUID LEAK