2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from May 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface of the vehicle, wash off and remove it completely.


3. DISCONNECT FRONT FLEXIBLE HOSE

  1. C165870
    Remove the bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly.


4. REMOVE DISC BRAKE CYLINDER ASSEMBLY

  1. C165871E01
    Hold the front disc brake cylinder slide pins and remove the 2 bolts and disc brake cylinder assembly.

    NOTICE:
    Remove the disc brake cylinder assembly while holding both of the brake pads because of the anti-squeal springs may fall off the brake pads.

← COMPONENTS (from May 2007)DISASSEMBLY (from May 2007) →