2007-2013 Highlander Kluger · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE FRONT DISC BRAKE PAD

  1. C165873
    Remove the 2 anti-squeal springs.

  1. C165872
    Remove the 2 brake pads from the front disc brake cylinder mounting.


2. REMOVE FRONT ANTI-SQUEAL SHIM
  1. Remove the 2 anti-squeal shims and the 2 pad wear indicators from the pads.


3. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

  1. C165874
    Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.

    NOTICE:
    Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that they can be reinstalled to their original position.


4. REMOVE NO. 1 FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C165877
    Remove the No. 1 front disc brake cylinder slide pin from the front disc brake cylinder mounting.


5. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C165878
    Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.


6. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING

  1. C132797E01
    Using a screwdriver, remove the front disc brake cylinder slide bushing from the No. 2 front disc brake cylinder slide pin.

    NOTICE:
    Do not damage the No. 2 front disc brake cylinder slide pin.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

  1. C165876
    Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


8. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

  1. C165875
    Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.


9. REMOVE FRONT DISC BRAKE PISTON

  1. C165880
    Place a shop rag or a piece of cloth between the disc brake pistons and the disc brake cylinder assembly.

  1. Using compressed air, remove one of the disc brake pistons from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the front disc brake piston when using compressed air.

    NOTICE:
    Do not allow any brake fluid to spatter.


10. REMOVE CYLINDER BOOT

  1. C165881E01
    Using a screwdriver, remove the 2 cylinder boots.

    NOTICE:
    Be careful not to damage the front disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.


11. REMOVE PISTON SEAL

  1. C165882E01
    Using a screwdriver, remove the 2 piston seals from the disc brake cylinder assembly.

    NOTICE:
    Be careful not to damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.


12. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

13. REMOVE FRONT DISC BRAKE BLEEDER PLUG

14. REMOVE FRONT DISC

  1. C165879E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.

← REMOVAL (from May 2007)INSPECTION (May 2007 – Jul 2008) →