2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

Cruise Main Indicator Light Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

  1. The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.
  2. The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester main switch on.

  1. Select the following menu items: Body Electrical / Combination Meter / Active Test.

  1. Check the CRUISE main indicator light by performing the Active Test.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    CRUISE main indicator light
    Indicator light BLINK / OFF
    -

    OK:
    The indicator light blinks/goes off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester main switch on.

  1. Select the following menu items: Powertrain / Cruise Control / Data List.

  1. Check the Data List for proper functioning of the CRUISE main indicator light.

    ECM (Cruise control): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CRUISE" on
    OFF: "CRUISE" off
    -

    OK:
    When the cruise control main switch is operated, the display changes as shown above.



NG
REPLACE ECM (for 2GR-FE) (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise Main Indicator Light Circuit (May 2007 – Jul 2008)Cruise Main Indicator Light Circuit (from Jul 2010) →