Cruise Main Indicator Light Circuit
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
- The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.
- The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester main switch on.
Select the following menu items: Body Electrical / Combination Meter / Active Test.
Check the CRUISE main indicator light by performing the Active Test.
Combination Meter: Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp Cruise
CRUISE main indicator light
Indicator light BLINK / OFF
-
- OK:
- The indicator light blinks/goes off.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester main switch on.
Select the following menu items: Powertrain / Cruise Control / Data List.
Check the Data List for proper functioning of the CRUISE main indicator light.
ECM (Cruise control): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Indicator M-CPU
Cruise indicator signal (Main CPU) / ON or OFF
ON: "CRUISE" on
OFF: "CRUISE" off
-
- OK:
- When the cruise control main switch is operated, the display changes as shown above.
|
|
||||
| OK | ||
| ||
