2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

GPS Mark is not Displayed

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely faint radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    The mark appears.



NG
Go to step 2
OK

NORMAL OPERATION

2. CHECK SURROUNDINGS

  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction, and time. For examples, see the following illustration.

    I100196E07

    OK:
    The GPS mark is displayed.



NG
Go to step 3
OK

SYSTEM RETURNS TO NORMAL

3. CHECK GPS INFORMATION (NAVIGATION CHECK MODE)
I102403E01
  1. Enter the "Navigation Check" mode (GPS Information) (Click here).

  1. Check how many of the following codes appear in the "STS" column.

    For DENSO Made:
    T, P

    For AISIN AW Made:
    08H, 04H

    OK:
    At least 3 codes appear.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Current Position Display does not Appear (from Jul 2010)GPS Mark is not Displayed (Aug 2008 – Jun 2010) →