2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Display does not Dim when Light Control Switch is Turned ON

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK IMAGE QUALITY SETTING

  1. E125813E01
    Enter the display adjustment screen by pressing the "DISP" switch.

  1. Turn the light control switch to the TAIL position.

  1. Check if "Day Mode" on the display adjustment is ON.

    OK:
    "Day Mode" is ON.



NG
Go to step 2
OK

TURN "Day Mode" SETTING OFF

2. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

  1. E125810E01
    Enter the "Display Check" mode (Vehicle Signal Check) (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    TAIL or ON
    ON
    OFF
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Illumination for Panel Switch does not Come on with Tail Switch ON (from Jul 2012)Display does not Dim when Light Control Switch is Turned ON (Aug 2008 – Jun 2010) →