2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Display does not Dim when Light Control Switch is Turned ON

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK DISPLAY SETTING

  1. E190565E04
    Enter the display quality adjustment screen.

  1. Turn the light control switch to the tail position.

  1. Check if "Day Mode" on the display quality adjustment screen is on.

    OK:
    "Day Mode" is on.

    Text in Illustration 
    *a
    Example



NG
Go to step 2
OK

TURN "Day Mode" SETTING OFF

2. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E176538
    Enter the "Vehicle Signal Check Mode" screen (Check Vehicle Signal) (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or on
    ON
    Off
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Display does not Dim when Light Control Switch is Turned ON (Aug 2008 – Jun 2010)Display does not Dim when Light Control Switch is Turned ON (from Jul 2012) →