Check if the system voice recognition level is low when recognizing a particular voice.
Result:
Result
Proceed to
System voice recognition level is low with any voice.
A
System voice recognition level is low only for a particular voice.
B
HINT:
System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.
B
END
A
2. CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks on the map disc
NG
REPLACE MAP DISC
OK
3. CHECK MAP DISC
Check for dirt on the map disc surface.
OK:
No dirt is on the map disc surface.
NOTICE:
Do not use a conventional record cleaner or anti-static preservative.
HINT:
If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.
NG
CLEAN MAP DISC
OK
4. CHECK MICROPHONE (OPERATION CHECK)
Enter the "Microphone&Voice Recognition Check" screen (Check Mic & Voice Recognition) (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
HINT:
Voice can be recorded up to 5 seconds.
Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
OK:
All check results are normal.
Text in Illustration
*a
Microphone Input Level Meter
*b
Recording Switch
*c
Stop Switch
*d
Play Switch
*e
Recording Indicator
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)