2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Voice Recognition Difficulty

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CONDITION
  1. Check if the system's voice recognition level is low when recognizing a particular voice.

    OK:
    System's voice recognition level is low with any voice.

    HINT:
    System's voice recognition level varies depending on voice and pronunciation. This is not a malfunction.



NG
END
OK


2. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc.



NG
REPLACE MAP DISC
OK


3. CHECK MAP DISC

  1. I100201E04
    Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.

    HINT:
    If the disc is dirty, clean the disc by wiping the disc's surface radially with a soft cloth.



NG
CLEAN MAP DISC
OK


4. CHECK MICROPHONE (NAVIGATION CHECK MODE)

  1. E120056E03
    Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END


← Voice Recognition Difficulty (May 2007 – Jul 2008)Voice Recognition Difficulty (Jul 2010 – Jun 2012) →