2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Position Mark Deviates Greatly

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK GPS MARK

  1. E137171E02
    Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.



NG
GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


2. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

  1. E120089
    Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

    OK:
    The readings are almost equal.



NG
GO TO "SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

  1. E120101E01
    Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift Lever Position
    Display
    Except Reverse
    OFF
    Reverse
    ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Map Disc cannot be Inserted (from Jul 2010)Vehicle Position Mark Deviates Greatly (Aug 2008 – Jun 2010) →