2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Screen Flicker or Color Distortion

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK DISPLAY SETTING

  1. E120095E01
    Enter the display adjustment screen by pressing the "DISP" switch.

  1. Reset display settings (contrast, brightness) and check that the screen appears normal.

  1. E120096E04
    Press the "INFO" switch and then select "Screen Setting."

  1. E153219E01
    Set "Switch Color" to initial color and check if the display returns to normal.

    Initial color:
    for China: Orange color
    for Except China: Green color

    OK:
    The display returns to normal.



NG
Go to step 2
OK

END

2. CHECK CABIN
  1. Check that the cabin temperature is higher than -20°C (-4.0°F).

    OK:
    The cabin temperature is higher than -20°C (-4.0°F).



NG
HEAT CABIN AND RECHECK TEMPERATURE
OK


3. CHECK COLOR BAR (DISPLAY CHECK MODE)

  1. I100037E05
    Enter the "Display Check" mode (Color Bar Check) (Click here).

  1. Check that the color bars match the displayed names.

    OK:
    Color bars match the displayed names.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4. CHECK NAVI COLOR BAR (NAVIGATION CHECK MODE)
I100050E04
  1. Enter the "Navigation Check" mode (NAVI Color Bar Check) (Click here).

  1. Check that the color bars match the displayed names.

    OK:
    Color bars match the displayed names.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Panel does not Open, Tilt or Tilts Improperly (from Jul 2010)Screen Flicker or Color Distortion (Aug 2008 – Jun 2010) →