Screen Flicker or Color Distortion
Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012
Versions by build date: Jul 2010 – Jun 2012 from Jul 2012
INSPECTION PROCEDURE
| 1. CHECK DISPLAY SETTING |
 |
- Enter the display adjustment screen by pressing the "DISP" switch.
Reset display settings (contrast, brightness) and check that the screen appears normal.
- OK:
- The display returns to normal.
Text in Illustration
*a
|
Example
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
|
| 2. CHECK CABIN |
 |
Check that the temperature in the cabin is neither -20°C (-4°F) or lower nor 65°C (149°F) or higher.
- HINT:
- The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.
- OK:
- Temperature in the cabin is between -20°C (-4°F) and 65°C (149°F).
|
NG |
 |
|
| HEAT CABIN AND RECHECK TEMPERATURE |
|
|
| OK |
|
 |
|
| 3. CHECK COLOR BAR (OPERATION CHECK) |
 |
- Enter the "Color Bar Check Mode" screen. Refer to Check Color Bar in Operation Check (Click here).
Check that the color bars match the displayed names.
- OK:
- Color bars match the displayed names.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|