2007-2013 Highlander Kluger · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE REAR DRIVE SHAFT SNAP RING

  1. C057543E04
    Using a screwdriver, remove the rear drive shaft snap ring.


2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP

  1. C166351
    Using pliers, remove the rear drive shaft inboard joint boot clamp as shown in the illustration.


3. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP

  1. C166350
    Using pliers, remove the No. 2 rear drive shaft inboard joint boot clamp as shown in the illustration.


4. SEPARATE INBOARD JOINT BOOT
  1. Separate the rear drive shaft inboard joint boot from the inboard joint assembly.


5. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY
  1. Remove the grease from the inboard joint assembly.

  1. C166352E01
    Put matchmarks on the rear drive shaft inboard joint assembly and rear drive shaft outboard joint shaft assembly.

    NOTICE:
    Do not use a punch for the marks.

  1. Remove the rear drive shaft inboard joint assembly from the rear drive shaft outboard joint shaft assembly.

  1. C166353
    Using a snap ring expander, remove the snap ring.

  1. C166354E01
    Put matchmarks on the rear drive shaft outboard joint shaft assembly and tripod joint.

    NOTICE:
    Do not use a punch for the marks.

  1. Using a brass bar and hammer, remove the tripod joint from the outboard joint shaft assembly.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot, rear drive shaft inboard joint boot clamp and No. 2 rear drive shaft inboard joint boot clamp.


6. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP

  1. C166356
    Using pliers, remove the rear drive shaft outboard joint boot clamp as shown in the illustration.


7. REMOVE NO. 2 REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP

  1. C166355
    Using pliers, remove the No. 2 rear drive shaft outboard joint boot clamp as shown in the illustration.


8. REMOVE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft assembly.

  1. Remove the old grease from the rear drive outboard joint shaft assembly.

    NOTICE:
    Do not disassemble the outboard joint.


9. REMOVE REAR DRIVE SHAFT DUST COVER

  1. C166357E01
    Using SST and a press, remove the rear drive shaft dust cover.
    SST
    09950-00020  

    NOTICE:
    Be careful not to drop the rear drive shaft inboard joint assembly. Do not overtighten SST.

← REMOVAL (from Jul 2010)INSPECTION (from May 2007) →