B2799 Engine Immobiliser System Malfunction
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box (immobiliser code ECU); 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box (immobiliser code ECU) and ECM is different and an engine start is attempted. Before troubleshooting this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU (smart key ECU assembly) DTCs first.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2799 |
One of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
- If the ECM is replaced, register the ECU communication ID.
- If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
| 1. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 is not output.
|
|
||||
| OK | ||
| ||
| 2. RE-REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID.
| NEXT | |
| 3. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 is not output.
|
|
||||
| OK | ||
| ||
| 4. CHECK CONNECTION OF CONNECTOR |
Turn the engine switch off.
Check that the connectors are properly connected to the ECM and the ID code box (immobiliser code ECU).
- OK:
- Connectors are properly connected.
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (ID CODE BOX - ECM) |
Disconnect the ID code box (immobiliser code ECU) and ECM connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D28-5 (EFII) - D55-20 (IMO)
Always
Below 1 Ω
D28-6 (EFIO) - D55-14 (IMI)
Always
Below 1 Ω
D28-5 (EFII) - Body ground
Always
10 kΩ or higher
D28-6 (EFIO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 6. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 7. REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID.
| NEXT | |
| 8. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 is not output.
|
|
||||
| OK | ||
| ||
