2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

FAIL-SAFE CHART

System information · Vehicles built from May 2007

HINT:
If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition
Auto Cancel Condition
Re-operation Condition
CRUISE main indicator light blinks
  1. There is open or short in stop light switch circuit
  2. There is problem with vehicle speed signal
Turn cruise control main switch on again
  1. There is problem with input circuit of stop light switch circuit
  2. There is problem with cancel circuit
Turn ignition switch off and then on again
Cruise control is cancelled (The indicator light remains on)
At the following conditions, the stored vehicle speed is maintained.
  1. Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while running with cruise control on
  2. VSC operates
Push cruise control main switch to + (ACCEL)/RES (RESUME)
Vehicle speed is lower than stored speed by approx. 16 km/h (10 mph) or more
Push cruise control main switch to - (COAST)/SET
Cruise control is cancelled (The indicator light is off)
There is a problem with throttle position sensor and motor
Turn ignition switch off and then on again
← DTC CHECK / CLEAR (from Jul 2010)DATA LIST / ACTIVE TEST (May 2007 – Jun 2010) →