2007-2013 Highlander Kluger · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE VALVE STEM CAP
  1. Remove the valve stem caps from the cylinder heads.

    HINT:
    Arrange the removed parts in the correct order.


2. REMOVE INTAKE VALVE

  1. A129714E01
    Using SST, compress the inner compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, inner compression spring and intake valve.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE EXHAUST VALVE

  1. A129715E01
    Using SST, compress the inner compression spring and remove the valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, inner compression spring and exhaust valve.

    HINT:
    Arrange the removed parts in the correct order.


4. REMOVE VALVE STEM OIL SEAL

  1. A120701E01
    Using needle-nose pliers, remove the valve stem oil seals.


5. REMOVE VALVE SPRING SEAT

  1. A120702E01
    Using compressed air and a magnetic finger, remove the valve spring seats by blowing air onto them.


6. REMOVE NO. 1 STRAIGHT SCREW PLUG

  1. A129718E05
    Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets.

    NOTICE:
    If water leaks from a straight screw plug or the plug is corroded, replace it.


7. REMOVE NO. 2 STRAIGHT SCREW PLUG

  1. A129719E05
    Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.

    NOTICE:
    If water leaks from a straight screw plug or the plug is corroded, replace it.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →