2007-2013 Highlander Kluger · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL NO. 1 STRAIGHT SCREW PLUG

  1. A129718E05
    Using a 10 mm hexagon wrench, install 4 new gaskets and the 4 No. 1 straight screw plugs.

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }


2. INSTALL NO. 2 STRAIGHT SCREW PLUG

  1. A129719E05
    Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 No. 2 straight screw plugs.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }


3. INSTALL VALVE SPRING SEAT
  1. Install the valve spring seats to the cylinder head.


4. INSTALL VALVE STEM OIL SEAL

  1. A094934E04
    Apply a light coat of engine oil to new valve stem oil seals.

    NOTICE:
    Pay attention when installing the intake and exhaust valve stem oil seals. For example, installing the intake valve stem oil seal into the exhaust side or installing the exhaust valve stem oil seal to the intake side can cause installation problems later.

    HINT:
    The intake valve oil seals are gray and the exhaust valve oil seals are black.

  1. A124592E02
    Using SST, push in the oil seals.
    SST
    09201-41020  

    NOTICE:
    Failure to use SST will cause the seal to be damaged or improperly seated.


5. INSTALL EXHAUST VALVE

  1. A094936E04
    Apply a sufficient coat of engine oil to the tip area of the exhaust valve shown in the illustration.

  1. Install the exhaust valve, inner compression spring and valve spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to the original locations.

  1. A129715E01
    Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. A131896
    Using a plastic hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the retainer.


6. INSTALL INTAKE VALVE

  1. A094935E10
    Apply a sufficient coat of engine oil to the tip area of the intake valve shown in the illustration.

  1. Install the intake valve, inner compression spring and valve spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to their original locations.

  1. A129714E01
    Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
    SST
    09202-70020   (09202-00010)

  1. A131894
    Using a plastic hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the retainer.


7. INSTALL VALVE STEM CAP
  1. Apply a light coat of engine oil to the valve stem caps.

  1. Install the valve stem caps on the valves.

← REPLACEMENT (from May 2007)REPAIR (from May 2007) →