2007-2013 Highlander Kluger · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A141357E01
    Disconnect the connector and remove the fuel sender gauge from the fuel suction tube.


2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

  1. A138657E01
    Using needle nozzle pliers, remove the E-ring.

  1. A141315E01
    Disengage the 2 claws of the No. 1 fuel suction support and remove the fuel suction plate with the fuel filter from the No. 1 fuel sub-tank.

  1. Remove the spring from the fuel suction plate.

  1. A141317E01
    Disengage the claw of the jet pump nozzle.

  1. Separate the fuel pump filter hose.


3. DISCONNECT FUEL PUMP HARNESS

  1. A139181E01
    Disconnect the fuel pump harness connector.

    NOTICE:
    Do not separate the tube indicated in the illustration (Click here).


4. REMOVE FUEL PUMP

  1. A105596
    Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws on the filter and remove the fuel pump from the fuel filter.

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.

  1. A175690
    Disconnect the fuel pump connector.

  1. A125203E02
    Remove the O-ring from the fuel filter.


5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

  1. A124272E02
    Remove the fuel pressure regulator from the fuel filter.

  1. A096585E03
    Remove the 2 O-rings from the fuel pressure regulator.


6. REMOVE NO. 1 FUEL SUCTION SUPPORT

  1. A124271E01
    Using a screwdriver with the tip taped, disengage the claw and remove the No. 1 fuel suction support.

← REMOVAL (from Jul 2010)DISASSEMBLY (Aug 2008 – Jun 2010) →