DISASSEMBLY
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE FUEL SENDER GAUGE ASSEMBLY |
 |
- Disconnect the connector and remove the fuel sender gauge from the fuel suction tube.
| 2.
REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY |
 |
- Using needle nozzle pliers, remove the E-ring.
- Disengage the 2 claws of the No. 1 fuel suction support and remove the fuel suction plate with the fuel filter from the No. 1 fuel sub-tank.
Remove the spring from the fuel suction plate.
- Disengage the claw of the jet pump nozzle.
Separate the fuel pump filter hose.
| 3.
DISCONNECT FUEL PUMP HARNESS |
 |
- Disconnect the fuel pump harness connector.
- NOTICE:
- Do not separate the tube indicated in the illustration (Click here).
| 4.
REMOVE FUEL PUMP |
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws on the filter and remove the fuel pump from the fuel filter.
- NOTICE:
- Do not damage the fuel filter.
- Do not remove the suction filter.
- Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
- Disconnect the fuel pump connector.
- Remove the O-ring from the fuel filter.
| 5.
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Remove the fuel pressure regulator from the fuel filter.
- Remove the 2 O-rings from the fuel pressure regulator.
| 6.
REMOVE NO. 1 FUEL SUCTION SUPPORT |
 |
- Using a screwdriver with the tip taped, disengage the claw and remove the No. 1 fuel suction support.