2007-2013 Highlander Kluger · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL NO. 1 FUEL SUCTION SUPPORT

  1. A125428E02
    Install the No. 1 fuel suction support to the fuel filter.


2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

  1. A097616E09
    Apply a light coat of gasoline or spindle oil to 2 new O-rings, then install them onto the fuel pressure regulator.

  1. A124272E02
    Install the fuel pressure regulator to the fuel filter.


3. INSTALL FUEL PUMP

  1. A091831E02
    Apply gasoline to a new O-ring and install it to the fuel filter.

  1. A124273E01
    Engage the 5 claws on the fuel filter and install the fuel pump with the pump filter.


4. CONNECT FUEL PUMP HARNESS

  1. A124274E01
    Connect the fuel pump harness connector.

    NOTICE:
    Do not separate the tube indicated in the illustration (Click here).


5. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY

  1. A141316E01
    Install the fuel pump filter tube while aligning it to the installation position of the No. 1 fuel sub-tank.

  1. Connect the jet pump nozzle.

  1. A139157E02
    Make sure that the fuel tube passes under the protrusion of the fuel filter, and engage the claw of the No. 1 fuel suction support.

  1. Install the spring to the fuel suction plate shaft and install it to the No. 1 fuel sub-tank.

  1. A138657E01
    Install a new E-ring.


6. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A141357E02
    Slide the fuel sender gauge to fit the claw.

  1. Connect the fuel sender gauge connector.

← REASSEMBLY (May 2007 – Jul 2008)REASSEMBLY (from Jul 2010) →