REASSEMBLY
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL NO. 1 FUEL SUCTION SUPPORT |
 |
- Install the No. 1 fuel suction support to the fuel filter.
| 2.
INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Apply a light coat of gasoline or spindle oil to 2 new O-rings, then install them onto the fuel pressure regulator.
- Install the fuel pressure regulator to the fuel filter.
| 3.
INSTALL FUEL PUMP |
 |
- Apply gasoline to a new O-ring and install it to the fuel filter.
- Engage the 5 claws on the fuel filter and install the fuel pump with the pump filter.
| 4.
CONNECT FUEL PUMP HARNESS |
 |
- Connect the fuel pump harness connector.
- NOTICE:
- Do not separate the tube indicated in the illustration (Click here).
| 5.
INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY |
 |
- Install the fuel pump filter tube while aligning it to the installation position of the No. 1 fuel sub-tank.
Connect the jet pump nozzle.
- Make sure that the fuel tube passes under the protrusion of the fuel filter, and engage the claw of the No. 1 fuel suction support.
Install the spring to the fuel suction plate shaft and install it to the No. 1 fuel sub-tank.
- Install a new E-ring.
| 6.
INSTALL FUEL SENDER GAUGE ASSEMBLY |
 |
- Slide the fuel sender gauge to fit the claw.
Connect the fuel sender gauge connector.