2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT WHEEL RH

2. REMOVE ENGINE UNDER COVER ASSEMBLY

  1. A171849
    Remove the 2 bolts and engine under cover assembly RR.

  1. A171850
    Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.


3. REMOVE NO. 1 ENGINE UNDER COVER

  1. A237657
    Remove the 6 bolts, 2 clips and No. 1 engine under cover.


4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

  1. A176043
    Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.

  1. A176044
    Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly RH.

  1. Remove the pad from the front fender moulding sub-assembly RH.

  1. Remove the 2 clips No. 4 from the front fender moulding sub-assembly RH.

  1. A176045
    Remove the front fender side protector from the front fender moulding sub-assembly RH.


5. REMOVE FRONT FENDER LINER RH

  1. B258290E01
    Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

  1. B260030
    Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 3 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. B260028
    Remove the 5 clips

  1. Remove the bolt, 8 screws and front fender liner RH.


6. REMOVE FRONT FENDER APRON SEAL RH

  1. A171853
    Remove the 2 bolts, clip and front fender apron seal RH.


7. REMOVE V-RIBBED BELT

  1. A162386E01
    Using SST, release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner assembly.
    SST
    09961-00950  

  1. A095070
    While turning the V-ribbed belt tensioner assembly counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSPECTION (from May 2007) →