2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT V-RIBBED BELT

  1. A088652
    Visually check the V-ribbed belt for excessive wear, frayed cords, etc.
    If any defect has been found, replace the V-ribbed belt.

    HINT:
    If the V-ribbed belt has chunks missing from its ribs, it should be replaced.

    HINT:
    1. A "new V-ribbed belt" is a V-ribbed belt which has been used for less than 5 minutes with the engine running.
    2. A "used V-ribbed belt" is a V-ribbed belt which has been used for 5 minutes or more with the engine running.


INSPECT V-RIBBED BELT TENSIONER ASSEMBLY
  1. Check that nothing gets caught in the V-ribbed belt tensioner assembly by turning it clockwise and counterclockwise.
    If a malfunction exists, replace the V-ribbed belt tensioner assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →