2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT SPIRAL CABLE
  1. If there are any defects as mentioned below, replace the spiral cable with a new one:

    1. Scratches, cracks, dents or chips on the connector or the spiral cable.

  1. E144333E09
    Inspect the spiral cable.

    1. Measure the resistance according to the value(s) in the table below.

      NOTICE:
      To avoid breaking of the spiral cable, do not turn the spiral cable more than necessary.

      If the value is not within the specified range, replace the spiral cable.
      Standard resistance 
      Tester connection
      Condition
      Specified condition
      z2-1 - D53-8 (HO)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      If the result is not as specified, replace the spiral cable.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →