REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed below are for the LH side.
| 1.
PRECAUTION |
 |
- CAUTION:
- Be sure to read "PRECAUTION" thoroughly before servicing (Click here).
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3.
REMOVE FRONT DOOR SCUFF PLATE
|
 |
- Disengage the 8 claws and guide, and remove the front door scuff plate LH.
| 4.
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
|
 |
- Remove the front door opening trim weatherstrip LH.
| 5.
REMOVE REAR DOOR SCUFF PLATE
|
 |
- Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.
| 6.
DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
|
 |
- Remove the rear door opening trim weatherstrip LH.
| 7.
REMOVE LOWER CENTER PILLAR GARNISH
|
 |
- Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.
| 8.
REMOVE SIDE AIRBAG SENSOR |
 |
Disconnect the connector from the side airbag sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
- Remove the bolt and disengage the pin, and remove the side airbag sensor.
- NOTICE:
- Loosen the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.