2007-2013 Highlander Kluger · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT DOOR SCUFF PLATE

  1. B173224
    Disengage the 8 claws and guide, and remove the front door scuff plate LH.


4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B173234
    Remove the front door opening trim weatherstrip LH.


5. REMOVE REAR DOOR SCUFF PLATE

  1. B173228
    Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.


6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

  1. B173232
    Remove the rear door opening trim weatherstrip LH.


7. REMOVE LOWER CENTER PILLAR GARNISH

  1. B173230
    Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.


8. REMOVE SIDE AIRBAG SENSOR
  1. Disconnect the connector from the side airbag sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. C165113
    Remove the bolt and disengage the pin, and remove the side airbag sensor.

    NOTICE:
    Loosen the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →