REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed below are for the LH side.
| 1.
PRECAUTION |
 |
- CAUTION:
- Be sure to read "PRECAUTION" thoroughly before servicing (Click here).
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3.
REMOVE COOL AIR INTAKE DUCT SEAL
|
 |
- Remove the 11 clips and cool air intake duct seal.
| 4.
REMOVE RADIATOR GRILLE
|
 |
- Put protective tape around the radiator grille.
- Remove the 2 bolts and 4 clips.
- Disengage the 6 claws and 4 guides, and remove the radiator grille.
| 5.
REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the screw.
- HINT:
- Use the same procedure for the RH side and LH side.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 7 screws and clip.
- Disengage the 4 claws and disconnect the front bumper assembly.
- HINT:
- Use the same procedure for the RH side and LH side.
Remove the front bumper assembly.
| 6.
REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the screw.
- HINT:
- Use the same procedure for the RH side and LH side.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 7 screws and clip.
- Disengage the 4 claws and disconnect the front bumper assembly.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each fog light connector, and then remove the front bumper assembly.
| 7.
REMOVE REAR FENDER SPLASH SHIELD SUB-ASSEMBLY
|
 |
- Disengage the 3 clips and 3 guides, and remove the rear fender splash shield sub-assembly.
| 8.
REMOVE HEADLIGHT ASSEMBLY
|
 |
- Remove the bolt and 2 screws.
Disengage the claw and disconnect the headlight assembly.
- Disengage the clamp.
Disconnect the connectors and remove the headlight assembly.
| 9.
REMOVE FRONT AIRBAG SENSOR |
 |
Disconnect the connector from the front airbag sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
- Remove the 2 bolts.
- NOTICE:
- Loosen the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.
Disengage the 2 claws and pin, and remove the front airbag sensor from the body.