2007-2013 Highlander Kluger · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY

  1. C165107E01
    Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the clamp and instrument panel wire assembly on the front passenger airbag assembly.


2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

  1. C168042
    Engage the 5 hooks.

  1. C165105
    Install the front passenger airbag assembly with the 5 hooks on the instrument panel safety pad assembly.

  1. C165104
    Install the 2 screws.


3. INSTALL NO. 4 HEATER TO REGISTER DUCT

  1. B168379
    Install the No. 4 heater to register duct with the 3 screws <E>.


4. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
  1. Engage the 5 claws.

    NOTICE:
    Do not allow the wire harness to get caught in the claws.

  1. Install the 2 bolts <D> and nut <G>.

  1. Install the 2 clips.

    B168377E03

  1. Engage each clamp.

  1. Install the 2 passenger airbag bolts <A>.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect each connector and install the instrument panel safety pad assembly.

    B168376E01


5. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

  1. C165103
    Connect the connector.


6. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)

HINT:
Refer to the procedure from Install Front No. 2 Speaker Assembly (Click here).

← INSTALLATION (Aug 2008 – Jun 2010)DISPOSAL (May 2007 – Jul 2008) →