2007-2013 Highlander Kluger · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) cable is disconnected.

    CAUTION:
    Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

  1. Temporarily install the curtain shield airbag assembly to the body panel with the 11 hooks.

    NOTICE:
    Do not twist the curtain shield airbag assembly when installing it.

  1. Install 11 new bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    HINT:
    Tighten the bolts in the order shown in the illustration.


    C170631E01

  1. Connect the curtain shield airbag connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


    C168036


2. INSTALL ROOF HEADLINING ASSEMBLY
(Click here)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← INSTALLATION (Aug 2008 – Jun 2010)DISPOSAL (May 2007 – Jul 2008) →