2007-2013 Highlander Kluger · Service Manual BODY

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from May 2007


GENERAL
This system has the following functions: manual slide open and close; auto slide open and close; manual tilt up and down; auto tilt up and down; jam protection; and key off operation.

FUNCTION OF MAIN COMPONENT
Component
Outline
Sliding Roof Drive Gear Sub-assembly
(Sliding roof control ECU)
Sliding roof control ECU controls sliding roof motor to rotate forward and backward, which tilts or slides sliding roof glass.
Roof Console Box Assembly
(Sliding roof switch assembly)
Output of operation signals from built-in sliding roof switch to sliding roof control ECU is handled by roof console box assembly.

SYSTEM OPERATION
The sliding roof has the following features:
Function
Outline
Manual slide open and close
This function causes sliding roof to open (or close) when OPEN/CLOSE switch is pressed for a maximum of 0.3 seconds. Sliding roof stops as soon as the switch is released.
Auto slide open and close
This function causes sliding roof to fully open (or close) when OPEN/CLOSE switch is pressed for a minimum of 0.3 seconds.
Manual tilt up and down
This function causes sliding roof to tilt up (or tilt down) when UP/DOWN switch is pressed for a maximum of 0.3 seconds.
Auto tilt up and down
This function enables sliding roof to tilt up (or down) when UP/DOWN switch is pressed for a minimum of 0.3 seconds.
Jam protection
The jam protection function automatically stops sliding roof, or stops sliding roof and makes it open halfway (or fully tilted up) if a foreign object gets jammed in sliding roof during auto close operation (or auto tilt down operation).
Key off operation
Key off operation function makes it possible to operate sliding roof for approximately 43 seconds after ignition switch is turned off, if front doors are not opened.
Sliding roof open warning
When the ignition switch is turned from on (IG) to off and the driver's side door is opened when the sliding roof is open, the sliding roof control ECU sounds the buzzer in the combination meter assembly. Then, a warning message appears on the multi-information display.
← SYSTEM DIAGRAM (from May 2007)HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008) →