2007-2013 Highlander Kluger · Service Manual BODY

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the following procedures to troubleshoot the sliding roof system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (LIN)*
    1. Using the intelligent tester, check if the multiplex communication system is functioning normally.

      Result:
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B


    B.
    A

    4.CHECK FOR DTC*
    1. Delete the DTCs (Click here).

    2. Recheck for DTCs (Click here).

      HINT:
      If DTCs are detected frequently, replace the ECU.

      OK:
      DTC is not output.


    NG.
    OK

    5.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)
      2. Terminals of ECU (Click here)
      3. On-vehicle Inspection (Click here)
    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from May 2007)HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010) →