2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the system to enter the self-diagnostic mode. If a malfunction is present, DTCs will be output.

HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM

C116614E19

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - ECM)
E151266E02
  1. Disconnect the D31 connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D31-23 (TC) - D43-13 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - ECM)
OK


2. CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND)

  1. C126742E57
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D43-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BODY GROUND)
OK


3. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND)

  1. C126742E58
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D43-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS, CONNECTOR, OR EACH ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← TC and CG Terminal Circuit (May 2007 – Jul 2008)TC and CG Terminal Circuit (from Jul 2010) →