2007-2013 Highlander Kluger · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT BRAKE DISC INSIDE DIAMETER

  1. C132647
    Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.

    Standard inside diameter:
    190 mm (7.48 in.)

    Maximum inside diameter:
    191 mm (7.52 in.)

    If the inside diameter is more than the maximum, replace the rear disc.


INSPECT PARKING BRAKE SHOE LINING THICKNESS

  1. C166158
    Using a ruler, measure the thickness of the parking brake shoe lining.

    Standard thickness:
    2.5 mm (0.098 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)

    If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly.

    NOTICE:
    Always replace both the right and left parking brake shoes together.


INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT

  1. C166159
    Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit the disc.
    If the contact between the disc and the brake shoe lining is improper, repair it using a brake shoe grinder or replace the parking brake shoe assembly.

    NOTICE:
    Always replace both the right and left parking brake shoes together.

← DISASSEMBLY (from Jul 2010)REASSEMBLY (May 2007 – Jul 2008) →