Only Rear Door LH LOCK / UNLOCK Functions do not Operate
Circuit diagnosis · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The main body ECU (instrument panel junction block) receives lock/unlock switch signals and activates the door lock motor according to these signals.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT REAR DOOR LOCK ASSEMBLY |
 |
- Remove the rear door lock assembly LH (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Measurement Condition
|
Door Lock Condition
|
Specified Condition
|
6 - 9
|
Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1
|
Locked
|
10 kΩ or higher
|
6 - 9
|
Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4
|
Unlocked
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR CIRCUIT) |
 |
- Disconnect the instrument panel junction block connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
K4-1 (UL) - 1P-6
|
Always
|
Below 1 Ω
|
K4-4 (L) - 1P-11
|
Always
|
Below 1 Ω
|
K4-1 (UL) - Body ground
|
Always
|
10 kΩ or higher
|
K4-4 (L) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (DOOR UNLOCK DETECTION SWITCH CIRCUIT) |
 |
- Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
K4-6 (LSSR) - 1P-5
|
Always
|
Below 1 Ω
|
K4-6 (LSSR) - Body ground
|
Always
|
10 kΩ or higher
|
K4-9 (E) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
|