2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Only Rear Door RH LOCK / UNLOCK Functions do not Operate

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The main body ECU (instrument panel junction block) receives lock/unlock switch signals and activates the door lock motor according to these signals.

WIRING DIAGRAM

B164398E25

INSPECTION PROCEDURE


1. INSPECT REAR DOOR LOCK ASSEMBLY

  1. B164416E01
    Remove the rear door lock assembly RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    6 - 9
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    6 - 9
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1 Ω



NG
REPLACE REAR DOOR LOCK ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR CIRCUIT)

  1. B171384E01
    Disconnect the instrument panel junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J4-1 (UL) - 1F-18
    Always
    Below 1 Ω
    J4-4 (L) - 1F-5
    Always
    Below 1 Ω
    J4-1 (UL) - Body ground
    Always
    10 kΩ or higher
    J4-4 (L) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (DOOR UNLOCK DETECTION SWITCH CIRCUIT)

  1. B111708E37
    Disconnect the main body ECU (instrument panel junction block) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J4-6 (LSSR) - D6-5 (LSWR)
    Always
    Below 1 Ω
    J4-6 (LSSR) - Body ground
    Always
    10 kΩ or higher
    J4-9 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Only Rear Door LH LOCK / UNLOCK Functions do not Operate (from Jul 2010)Only Rear Door RH LOCK / UNLOCK Functions do not Operate (Aug 2008 – Jun 2010) →