2007-2013 Highlander Kluger · Service Manual SECURITIES

ID Code Box Power Source Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

This circuit provides power to operate the ID code box (immobiliser code ECU).

WIRING DIAGRAM

B151008E04

INSPECTION PROCEDURE

NOTICE:
If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.


1. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY)

  1. B107455E36
    Disconnect the ID code box (immobiliser code ECU) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D28-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND)

  1. B107455E37
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D28-8 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ID CODE BOX (IMMOBILISER CODE ECU)


← Security Indicator Light Circuit (from Jul 2010)Certification ECU Power Source Circuit (from May 2007) →