2007-2013 Highlander Kluger · Service Manual SECURITIES

Certification ECU Power Source Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

This is the power source circuit of the certification ECU (smart key ECU assembly).
The certification ECU (smart key ECU assembly) controls the following:
  1. Electrical key verification confirmation
  2. Indoor, outside and door oscillator control
  3. Entry door LOCK/UNLOCK request to the main body ECU (instrument panel junction block)
  4. Steering LOCK/UNLOCK request
  5. Immobiliser SET/UNSET request to the ID code box (immobiliser code ECU)

WIRING DIAGRAM

B171366E03

INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID.


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY)

  1. B171405E04
    Disconnect the certification ECU (smart key ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D36-1 (+B) - Body ground
    Always
    11 to 14 V
    D36-18 (IG) - Body ground
    Engine switch off
    Below 1 V
    D36-18 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    D36-19 (ACC) - Body ground
    Engine switch off
    Below 1 V
    D36-19 (ACC) - Body ground
    Engine switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BODY GROUND)

  1. B171405E03
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-17 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← ID Code Box Power Source Circuit (from May 2007)PRECAUTION (May 2007 – Jul 2008) →