ACC Signal Circuit
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The main body ECU receives the ACC signal to control the illuminated entry system.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the following menu items: Body Electrical / Main Body / Data List.
Read the display on the intelligent tester.
Main Body:
Tester Display
|
Measurement Item/Range
|
Normal Condition
|
Diagnostic Note
|
ACC SW
|
Ignition switch or engine switch ACC signal / ON or OFF
|
ON: Ignition switch on (ACC) OFF: Ignition switch off
|
-
|
- OK:
- Normal conditions listed above are displayed.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
| 2. INSPECT FUSE (ACC) |
 |
Remove the ECU-ACC fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
ECU-ACC fuse
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (ACC POWER SOURCE CIRCUIT) |
 |
- Measure the voltage between the loading slot of the fuse and body ground.
- Standard voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
ECU-ACC fuse terminal - Body ground
|
Ignition switch off
|
Below 1 V
|
Ignition switch on (ACC)
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
|