2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ACC Signal Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The main body ECU receives the ACC signal to control the illuminated entry system.

WIRING DIAGRAM

E136353E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Select the following menu items: Body Electrical / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Ignition switch or engine switch ACC signal / ON or OFF
    ON: Ignition switch on (ACC)
    OFF: Ignition switch off
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT FUSE (ACC)
  1. Remove the ECU-ACC fuse from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-ACC fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (ACC POWER SOURCE CIRCUIT)

  1. E142679E01
    Measure the voltage between the loading slot of the fuse and body ground.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    ECU-ACC fuse terminal - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← ACC Signal Circuit (Aug 2008 – Jun 2010)Headlight Relay Circuit (May 2007 – Jul 2008) →