2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT ACC RELAY

  1. A092673E46
    Using an ohmmeter, measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the ACC relay.

← ON-VEHICLE INSPECTION (from May 2007)ON-VEHICLE INSPECTION (from May 2007) →