2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT IGNITION RELAY

  1. Inspect the No. 1 ignition relay.

    1. A092673E23
      Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage is not applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage is applied to terminals 1 and 2
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 ignition relay.

  1. Inspect the No. 2 ignition relay.

    1. B016200
      Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage is not applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage is applied to terminals 1 and 2
      Below 1 Ω

      If the resistance is not as specified, replace the No. 2 ignition relay.

← ON-VEHICLE INSPECTION (from May 2007)COMPONENTS (from May 2007) →