2007-2013 Highlander Kluger · Service Manual BODY

TERMINALS OF ECU

System information · Vehicles built from May 2007


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
E124486E08
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage 
    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-38 (RDEF) - D33-14 (GND)
    W - W-B
    Rear defogger signal
    Ignition switch on (IG), Rear window defogger switch OFF
    11 to 14 V
    Ignition switch on (IG), Rear window defogger switch ON
    Below 1 V
    D33-1 (IG+) - D33-14 (GND)
    GR - W-B
    Power source (IG)
    Ignition switch on (IG)
    11 to 14 V
    Ignition switch off
    Below 1 V
    D33-21 (B) - D33-14 (GND)
    B - W-B
    Power source (Back-up)
    Always
    11 to 14 V
    Standard resistance 
    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness or amplifier.


CHECK AIR CONDITIONING CONTROL ASSEMBLY
B164283E03
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage 
    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E8-2 (IG+) - E8-10 (GND)
    V - GR
    Power source (IG)
    Ignition switch on (IG)
    11 to 14 V
    Standard resistance 
    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E8-10 (GND) - Body ground
    GR - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Jul 2010)DATA LIST / ACTIVE TEST (from May 2007) →