2007-2013 Highlander Kluger · Service Manual BODY

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menu.

    1. Select: Body / Air Conditioner /Active Test.

      Air Conditioner: 
      Tester Display
      Test Part
      Control Range
      Diagnostic Note
      Defogger Relay (Rear)
      Rear window defogger
      OFF/ON
      -

← TERMINALS OF ECU (from May 2007)Rear Window Defogger System does not Operate (May 2007 – Jul 2008) →