2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:
    Tire size
    Front kPa (kgf/cm2, psi)
    Rear kPa (kgf/cm2, psi)
    245/55R19 103S
    245/55R19 103H
    245/65R17 105S
    245/65R17 105H
    4 passengers or less
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    5 passengers or more
    210 (2.1, 30) *1
    220 (2.2, 32) *2
    230 (2.3, 33) *1
    240 (2.4, 35) *2

    *1: For diving under 160 km/h (100 mph)
    *2: For driving at 160 km/h (100 mph) or over

  1. C137874
    Using a dial indicator, check the runout of the tires.

    Tire runout:
    1.4 mm (0.055 in.) or less


ROTATE TIRES

  1. C163157E01
    Rotate the tires as shown in the illustration.


INSPECT WHEEL BALANCE

  1. C144018E05
    Check and adjust the off-the-car balance.

    Imbalance after adjustment:
    8.0 g (0.018 lb.) or less

    NOTICE:
    1. Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
    2. Do not touch the sticking surface of the tape.
    3. Adhere the sticking type balance weight to the flat position shown in the illustration.
    4. Push the balance weight securely with a finger to adhere it to the indicated position.
    5. Do not reuse balance weights.

    HINT:
    1. The inner side balance weight should be installed by clipping it to the rim.
    2. If necessary, check and adjust the on-the-car balance.


INSPECT FRONT AXLE HUB BEARING LOOSENESS

HINT:
Click here.


INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)

HINT:
Click here.


INSPECT REAR AXLE HUB BEARING LOOSENESS (for 4WD)

HINT:
Click here.


INSPECT FRONT AXLE HUB RUNOUT

HINT:
Click here.


INSPECT REAR AXLE HUB RUNOUT (for 2WD)

HINT:
Click here.


INSPECT REAR AXLE HUB RUNOUT (for 4WD)

HINT:
Click here.

← INSPECTION (May 2007 – Jul 2008)INSPECTION (from Jul 2010) →